fieldtrip
tools / databases / neon / codex

Neon in Codex.

Codex can work on your Neon databases and try changes on a branch, but deleting or resetting anything needs your OK. This is for the Codex app or Codex in your Terminal, on your own Mac or Linux computer.

passed Nov 16 · Neon

fieldtrip add neon

New to fieldtrip? Install it first: curl -fsSL fieldtrip.sh/install | sh

Codex can

  • Read your databases and data.
  • Make a branch to try changes on.
  • Show you the result before going live.

Asks you first

  • Delete a project, database or branch.
  • Reset a branch to an earlier point.

Try asking Codex

Paste one into Codex. Underneath: what it runs.

How it’s set up for Codex

the keyIn Codex's own settings, ~/.codex/config.toml, in the part that only applies to the commands Codex runs. Your Terminal can't see it.
the noteSaved as a skill in ~/.agents/skills/neon, where Codex looks. Codex reads it when you ask about Neon. It says how to use Neon, and what to check with you about first.
after setupQuit Codex and start it again. It reads its settings when it starts.
two checksCodex has its own settings for when it asks before running a command. fieldtrip's note adds a check that doesn't depend on them.
check itAsk Codex on your computer to run fieldtrip doctor. It should say “Running in Codex” and show a ✓ beside Neon.

Do this once.

  1. Make a key from your Neon project's own settings, so it reaches only that project. fieldtrip will give you the link.
  2. Paste your key when fieldtrip asks you to.

Your key goes into your Terminal when fieldtrip asks. It never goes through Codex’s chat.

Checked every night

Yes. Neon 9.5.0 passed all five checks, Mon, Nov 16 · 11:09 AM CST.

Each square is one night.

Other AIs

Neon in Claude Code → · Neon in Cursor →

← All of Neon: every AI, every version · Neon in Claude Code → · Neon in Cursor → · What’s a CLI?